Works like a champ. I also found that the service station is easily removed by placing, forward of and to the left of the motor, a screwdriver between the metal chassis and the service station, and prying it upward. Again, thanks for the help. I recently inserted a newly refilled cartridge. Usually but not always you have to install software and then plug in the device. I removed the two screws that are visible when the top cover is open but the case does not come off easily and I do not want to force it. Release the clip that secures the switches to free the cover from the printer.

Uploader: Arashizragore
Date Added: 3 December 2005
File Size: 63.16 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 92186
Price: Free* [*Free Regsitration Required]

Make sure to check any specific procedures for installation from HP. Scrape as much congealed ink as possible from inside the service station.

hp 845c deskjet – how to clean ink blobs

I found that the right cover does not easily come off. Do not post advertisements, offensive material, profanity, or personal attacks. Please sign in to comment. Please remember to be considerate of other members.

Also, what caused the buildup of congealed ink? Privacy Policy Terms of Use.

The last HP USB printer that I installed required that the printer not be connected until after the software was installed, and the system waas re-booted. That particular printer has a driver for usb and another for a parallel cable. You might want to wear latex gloves To remove the service station do the following.

I have an HP deskjet c printer.

HP Deskjet c Specs – CNET

Then reboot again and reinstall making sure that you are following the instructions as far as when to connect the printer. Remove the Torx T10 screw printerr the top of the right cover. Would someone please tell me how to open and clean the printer? Can anyone help me work out printsr my PC is randomly restarting? Poster rated this answer 0 Votes. Also please exercise your best judgment when posting in the forums–revealing personal information such as your e-mail address, telephone number, and address is not recommended.

Read Also:   Tda2009 datasheet eBook download

All submitted content is subject to our Terms Of Use. From the back, near the clean-out cover, insert a screwdriver between the right cover and the base coming in from the bottom.

hp c deskjet – how to clean ink blobs | FixYourOwnPrinter

I de-installed the existing software,re-booted ,disconnected the printer, installed the software. Track this discussion and email me when there are updates. Pull up on the right cover to disengage it where the removed bp845c went through.

When the printer was open I noticed inside, on the right side of the printer, blobs of congealed ink that resembled black grease. It comes right out. CleaningSeries Service Station Prepare to get your hands dirty.

Do the same operation in the pringer near the paper tray and the cover will release completely and hinge to the right. Reset Post Submit Post. Make sure that the device is listed properly. I agree with all of the hp845x and those things should be tried first. There is one Prinetr T10 screw in the front of the service station holding it in place. Remove the screw and unplug the motor cable, and the service station will lift from the front and slide out. This question was closed by the author 0 Votes.

Just where is the parking pad? If it is registering correctly you should be able to seeit in the registry or the task bar icon for Unplug and Eject Hardware.

Rate this post